您好,欢迎访问济南庆飞机械设备有限公司官网 网站

全国咨询热线:

15621892888
15550061228

当前位置:首页>新闻资讯>行业动态升降货梯的存放要注意什么?

升降货梯的存放要注意什么?

文章出处:http://www.qingfeijixie.cn/ 人气: 0 发表时间:2023-01-18
升降货梯如何正确存放:
How to store the elevator correctly:
一,应该停在干燥的环境。如果你不得不在外面停下来,你应该选择一个平坦的地面铺上木板。停车后用防水盖布覆盖。
1、 It should be stopped in a dry environment. If you have to stop outside, you should choose a flat ground and pave it with boards. After parking, cover it with waterproof cloth.
固定剪叉升降货梯
Fixed scissor lift cargo elevator
二,在长期停机和储存之前,必须对机器进行维护,对损坏的零件进行修理,并彻底清洗,以保持良好的技术状态。
2、 Before long-term shutdown and storage, the machine must be maintained, damaged parts must be repaired and thoroughly cleaned to maintain good technical condition.
三,机场的布置和布局应保证任何机械的进出不受其他机械的影响。
3、 The layout and layout of the airport shall ensure that the access of any machinery is not affected by other machinery.
四,机械燃油操纵杆应置于怠速位置,每个操纵杆都处于空档位置。
4、 The mechanical fuel control lever should be in the idle position, and each control lever should be in the neutral position.
升降货梯厂家
五,发动机储存。
5、 Engine storage.
清洁发动机中的冷却水。升降货梯是一种多功能升降机械设备,可分为固定式和移动式、导轨式、曲柄臂式、剪刀式、链条式、装卸平台式等。电梯通常用于救援和装饰。
Clean the cooling water in the engine. The cargo elevator is a multifunctional lifting mechanical equipment, which can be divided into fixed and mobile, guide rail, crank arm, scissors, chain, loading and unloading platform, etc. The elevator is usually used for rescue and decoration.
更换发动机机油。新机油通常是中性的,不会腐蚀发动机的金属部件。
Change the engine oil. The new oil is usually neutral and will not corrode the metal parts of the engine.
给油箱加满柴油,以免油箱生锈。如果条件允许,还应该添加防腐剂。
Fill the fuel tank with diesel to avoid rusting. If conditions permit, preservatives should also be added.
在液压升降机停机期间,发动机应每月启动一次,以使机器能够短距离运行,从而在每个零件的润滑部分建立新的油膜,以防止生锈。应该注意的是,冷却水应该在启动前注满,冷却水应该在结束时排出。
During the shutdown of the hydraulic elevator, the engine should be started once a month to enable the machine to run for a short distance, so as to establish a new oil film on the lubricating part of each part to prevent rust. It should be noted that the cooling water should be filled before starting, and the cooling water should be discharged at the end.