设备到货后我们先要做好安装前的准备，安装工程师需先对施工现场进行施工确认，再对施工现场进行水平测试。然后将设备运到施工现场后，我们施工人员需要清点所有施工工具以及升降货梯设备，一切准备就绪后，我们就可以进行施工安装了。

After the arrival of the equipment, we should first make preparations before installation. The installation engineer should first confirm the construction on the construction site, and then conduct level test on the construction site. Then, after the equipment is transported to the construction site, our construction personnel need to count all construction tools and elevator equipment. After everything is ready, we can carry out construction and installation.

那么当液压升降货梯安装好后我们应该怎样正确调试?升降货梯在安装移动时要注意,如果升降梯安装不当会很容易造成设备故障或事故，接下来下面河南液压升降货梯厂家就为大家普及一些升降设备安装后正确调试的知识，希望能够给大家提供帮助！

So how should we correctly debug the hydraulic elevator after it is installed? Pay attention to the installation and movement of the elevator. If the elevator is not installed properly, it will easily cause equipment failure or accident. Next, Henan hydraulic elevator manufacturer will popularize some knowledge of correct debugging of the elevator after installation, hoping to help you!

1、工作前穿戴好个人劳动保护用品，特别注意戴好防护帽，高空作业系好防护带，电工、焊工穿绝缘鞋，并检查所有使用的工具；

1. Wear personal labor protection articles before work, pay special attention to wearing protective helmets, fasten protective belts for high-altitude operation, electricians and welders wear insulating shoes, and check all tools used;

2、在调试升降机前一定穿好绝缘鞋、戴好绝缘手套或者站在绝缘垫上，否则禁止施工；

2. Before commissioning the elevator, be sure to wear insulating shoes, gloves or stand on the insulating pad, otherwise construction is prohibited;

3、在安装时，应先与现场施工单位负责人取得联系，共同研究双方在现场工作中的措施与注意事项，共同遵守执行；

3. During installation, contact with the person in charge of the on-site construction unit first, jointly study the measures and precautions of both parties in the on-site work, and jointly abide by and implement them;

4、升降货梯工作时在每层厅门外，挂有井下有人工作的标牌；

4. When the cargo elevator is working, there is a sign that someone is working underground outside the hall on each floor;

5、在井道工作时，采用36V工作照明灯，在轿厢内工作时采用12V工具照明灯；

5. When working in the hoistway, 36V working lamp is used, and 12V tool lamp is used when working in the lift car;

6、工作场所下面不准停人，下脚手架时不准滑下和跳下；

6. No one is allowed to stop under the workplace, and no one is allowed to slide and jump off the scaffold;

7、在调试中开车人员要配合好调试人员，精神要集中，听从调试人员的指挥；

7. During commissioning, the driving personnel shall cooperate well with the commissioning personnel, concentrate and obey the command of the commissioning personnel;

8、在调试电梯与井道作业时，严禁酒后操作、打闹、开玩笑，搞好协作，监护他人工作；

8. During the commissioning of elevator and hoistway operations, it is strictly prohibited to operate after drinking, make trouble and joke, do a good job in cooperation and supervise the work of others;

9、动用气、电焊时，要遵守气、电焊操作规程，注意防火；

9. When using gas and electric welding, observe the operating procedures of gas and electric welding and pay attention to fire prevention;