液压升降机在不同时段的保养细节是不一样的，液压升降机小编带您详细的了解一下。

The maintenance details of the hydraulic elevator are different in different periods. The small braid of the hydraulic elevator will let you know in detail.

一、日常保养

1、 Daily maintenance

升降机在保养时，如果需要人员进入到平台内部，一定要吊住升降机或撑起维修支撑，防止升降机突然下降而造成人员伤亡。

During the maintenance of the elevator, if people need to enter the platform, be sure to hang the elevator or support the maintenance support to prevent casualties caused by the sudden drop of the elevator.

1.注意检查滚轮、中间轴及轴承；油缸销轴及轴承；臂架销轴及轴承等部件的润滑度和磨损情况；

1. Check the roller, intermediate shaft and bearing; Oil cylinder pin shaft and bearing; Lubrication and wear of boom pin shaft, bearing and other components;

2.对上述各部件加注润滑油。延长轴承的使用寿命；

2. Fill the above components with lubricating oil. Prolong the service life of the bearing;

3.注意检查液压油的油质和油位。升降机升高时液压油面应高于油箱底部40-50mm。当液压油出现以下状况：油色变暗、油质发粘，或油中有砂砾等异物时，一定要及时更换液压油。一般的升降机的液压系统采用的都是32#液压油；

3. Check the oil quality and oil level of hydraulic oil. The hydraulic oil level shall be 40-50mm higher than the bottom of the oil tank when the elevator rises to high. When the hydraulic oil has the following conditions: the oil color becomes dark, the oil is sticky, or there are foreign matters such as gravel in the oil, the hydraulic oil must be replaced in time. The hydraulic system of general elevator adopts 32# hydraulic oil;

二、半年维护保养

2、 Half year maintenance

1.注意检查液压管道和接头。油管不得破损，接头不得松动；

1. Pay attention to check the hydraulic pipes and joints. The oil pipe shall not be damaged and the joint shall not be loose;

2.注意检查回油节流阀。在拆卸下回油节流阀后，要用压缩空气将柱塞吹净、用油洗净后，再重新安装。

2. Check the oil return throttle valve. After removing the oil return throttle valve, blow the plunger with compressed air and wash it with oil before reinstalling it.

三、年终保养

3、 Year end maintenance

1.注意检查液压和管道的连接部位。如果发现管道有破损应立即更换；连接部位有松动时应注意拧紧管接头；

1. Pay attention to check the connecting parts of hydraulic and pipeline. If the pipeline is found damaged, it shall be replaced immediately; When the connecting part is loose, pay attention to tightening the pipe joint;

2.卸下并拆开下降阀进行检查，用压缩空气将阀芯吹净后重新装上；

2. Remove and disassemble the lowering valve for inspection, and reinstall it after blowing the valve core with compressed air;

3.把油箱中的液压油全部放净后打开油箱，取出内部的吸油过滤器进行清洗，洗净后放回油箱，按照原位进行安装，油箱中重新注满新的液压油即可。

3. After all the hydraulic oil in the oil tank is drained, open the oil tank, take out the internal oil suction filter for cleaning, put it back into the oil tank after cleaning, install it in situ, and refill the oil tank with new hydraulic oil.

以上就是为大家介绍的有关电动液压货梯的详细介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务

The above is a detailed introduction to the electro-hydraulic cargo elevator. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service